Aviation Fuel Sample Containers for Tests Affected by Trace Contamination ( ASTM D) is the standard that addresses any and all of these concerns. Conshohocken, PA , USA, pursuant to license with ASTM International is based on ASTM D − 15, Standard Practice for Aviation. Buy ASTM D PRACTICE FOR AVIATION FUEL SAMPLE CONTAINERS FOR TESTS AFFECTED BY TRACE CONTAMINATION from SAI Global.
|Published (Last):||14 February 2006|
|PDF File Size:||2.97 Mb|
|ePub File Size:||20.8 Mb|
|Price:||Free* [*Free Regsitration Required]|
NOTE 5 – Although this practice attempts to minimize container effects wherever possible, electrical conductivity tests should be carried out directly on fuel in tankage or by drawing a sample for immediate testing. Drain the solvent and air dry. Please first verify your aetm before subscribing to alerts. Toggle navigation Toggle search.
Certain container types have been found suitable for some test methods but not for others. Amber glass bottles aetm less affected. An approval procedure for new containers is also given. For specific warning statements, see 5. The following procedure applies to circumstances where fuel samples will not be retained for longer than 24 h, preferably for shorter times.
Standards Subsctiption may be the perfect solution. Measurement significance therefore requires that the sample containers not add or adsorb any materials. Proceed to Checkout Continue Shopping. After the last flush is drained, the container may be filled for transport to the laboratory for testing. The Best Gets Better: Remember me for one month.
Sampling Can | ASTM D | ASTM D | IP 51
Contact with us now Your mail: Lubricant Storage and Handling. Current Issue Archive Advertise. New containers should be flushed three times with product being sampled.
Significance and Use 3. At the end of storage the sample should 4d306 tested for electrical conductivity and water separation. ASTM standards are accepted and used in research and development, product testing, quality systems and commercial transactions around the globe.
This standard is not included in any packages. Create your own user feedback survey. Advice for Improving Oil with Additives.
Alternatively, rinse with hot water, then deionized water or asrm, and air dry. How Desiccant Breathers Control Contamination. We have no amendments or corrections for this standard.
Immediately prior to sample collection, the container should be flushed three times with the sample being collected.
For each flush, the container should be closed and shaken for 1 min and the solvent replaced for the next flush. NOTE 4 – Soldered cans often contain residues of soldering flux or roll-oils on inside surfaces. Similar testing can be applied for other additives and properties.
Power by seonoco All Rights Reserved: However, a number of aviation fuel properties asfm established or affected by trace levels of polar or other compounds. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Some containers are adequate if the samples are used immediately but are not suitable for sample storage. Today, some 12, ASTM standards are used around the world to improve product quality, enhance safety, facilitate market access and trade, and build consumer confidence. If you like to setup a quick demo, let us know at support madcad. These properties should be determined by placing the sample directly into astmm measuring apparatus and not using containers to transport the sample to the measuring equipment.
Measurement significance therefore requires that the sample containers d430 add or adsorb any materials.
New ASTM Aviation Fuel Manual Now Available
The procedure therefore designates the containers to be used for each test procedure and describes prior cleaning, if any. After the last flush is drained, the container should be air-dried. Subscription pricing is determined by: